POWERMAX+ Fully Supervised Wireless Alarm Control System Installer Guide. Installation and Programming Guide (this manual - for your exclusive use). VISONIC - Powermax (Installation Manual in English) - Download >VISONIC. VISONIC - Powermax + (Powermax Plus) (User's guide in French) - Download.

• POWERMAX PRO Installer Guide Fully Supervised Wireless Alarm Control System TABLE OF CONTENTS 1. INTRODUCTION..3 4.4.21 “Not Active”..16 4.4.22 Back Light..16 2.

3 4 C Program For Magic Square here. .4.23 Duress..16 2.1 General Data..3 4.4.24 Piezo Siren..16 2.2 RF Section..4 4.4.25 Reset Option.. • SIA Event Codes..35 D10. Perimeter Zones.. 37 4/2 Event Codes..35 D11. Perimeter Follower Zones.37 Understanding the Scancom Reporting Protocol Data D12. Temperature Zone..37 Format..36 D13.

24-Hour Zones..37 APPENDIX D. Programmable Zone Types.36 D14. INTRODUCTION • The PowerMax Pro is a user and installer-friendly, 30-zone Special wall-mounted bracket permits installation without fully-supervised wireless control system. The system is having to open the unit’s plastic casing.

Designed to function in a way that appeals to the user but •. • 2.2 RF Section The backup periods, when the PowerMax Pro includes internal PowerLink with 1 active camera, GSM and Operating Frequencies (MHz): 315, 433 or 868.95 proximity reader, with external load connected between Receiver Type: Super-heterodyne, fixed frequency +12 / V+ terminal and GND terminal, is as follows: Receiver Range: 600 ft (180 m) in open space Battery Pack Battery pack. • Separate the back unit from the front unit Back unit Position the back unit on the desired mounting location and mark 4 drilling points Release on mounting surface screws Back unit Drill 4 holes and insert wall anchors Fasten the back unit with 4 screws Figure 3.1a –. • PHONE WIRING USING TERMINAL BLOCK CONNECTORS (NORTH AMERICA) 8-POSITION RJ-31X JACK RJ-31X PLUG GRAY BROWN LINE HOUSE FROM RJ-31X PHONES GREEN STREET GRAY RJ-31X BROWN CORD Figure 3.1b – Phone Wiring Phone wiring in the UK: Line terminals must be connected to pins 2 and 5 of the wall jack. For all installations: If DSL service is present on the phone line, you must route the phone line through a DSL filter (refer to MESSAGE TO THE INSTALLER on page 2 for further details). • Figure 3.1f.

-or- Through direct connection of the 12.5 VDC power supply to the expander card via the wall mounted switched AC/DC power supply (supplied by Visonic), as shown in Figure 3.1g. Extract either of these cable clamps. • POWER CONNECTION FOR USA ONLY 100-240V 50/60Hz 12.5VDC Wall Mounted Switched AC/DC Power Supply Figure 3.1g – Wall Mounted Switched AC/DC Power Supply Connection 3.6.3 Optional GSM/GPRS Module 3.6 Front Unit Preparation Mounting 3.6.1 Backup Battery Insertion Caution! Do not insert or remove the GSM module when Open battery compartment cover (see Figure 3.1h). • 3.7 Final Closure Connect the flat cables in their respective connectors (2 - 5, according to options). Front unit Back unit Close the panel and fasten the 2 screws.